Interested to Buy Any Domain ? << Click Here >> for more details...
for indiacation of turbine(china) bearing temperature what
type of sensor will be used(i.e. rtd or thermocouple or
themister ) ? why it is ? i need clear explanation ?
- 2 Answers
- 6360 Views
- I also Faced
- E-Mail Answers
Answer Posted / amsal
we use RTDs to measure the bearing temp of turbine because maximum temperature of turbine bearing reaches 120 C. and RTDs are better to measure that low range of temperature than a thermocouple. not due to vibration. But in GT V94.2 siemens we are using T/Cs instead of RTDs and its bearing temperature protection is 120C.
| Is This Answer Correct ? | 9 Yes | 0 No |
Post New Answer View All Answers
hi,i am doing 3 year in electronic and instrumentation engineering. what type of aptitude questions will be asked in a core industries and how can i improve my skills in instrumentation?
If P will increase then what will happen with PID?
can we copy the software from a transmitter using hht(hart 275) ?
How to control flow variations in magnetic flow maters..... When i will provide proper earthing?
what will the sending unit in the fuel gauge utilizes?
Pl send the model question paper of mahagenco account officer post
How to calibrate an pressure gauge with yantrika test bench?
The Design Calculation of Level Transmitter For Different Structure open & Closed Vessel, Eg. Diff. Level Tx., Capacitance For Continous Operation
What happen if I install my pressure transmitter below the elevation of pipe in natural gas service?
A length of steel pipe is used to carry sea water to a desalination plant. An adequate corrosion allowance must be specified and indicated in the piping specification, which affects the _________________________ of the pipe
what is the usage of QDV & VOLUME BOOSTER
why use 50% lel methane gas concentration for gas detector calibration instead of 60% lel gas concentration whereas the hi alarm set at 60% lel.
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
how to calculate signal cable sizing? and multipair cable sizing??explain in brief?
plz send me general of ongc
