Interested to Buy Any Domain ? << Click Here >> for more details...
can i get model question papers of mahagenco exam?
- 11 Answers
- 22263 Views
- MahaGenco, MSGEN, I also Faced
- E-Mail Answers
Answer Posted / anil sadashiv alladwar
i want model quastion of mahagenco
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
dear friends, i have seen flow as the selection critriea in presure guage (bourdon tube) and i would like to know what is the relation between flow and performance of pressure guage other parameters i found in the data sheet are pressure max. 1ksc temperature max. - 50 deg c line size - 80NB operating range - 1ksc pr. guage range - 0-2 ksc thank u,
describe flow nozzel principle?
If we increase only P what will be controller action ?
what is the difference between profibus and controlnet networking.
how to work MIL contol valve posistioner ?
TEMPERATURE VARIATION FOR FREQUENTLY.
State some of balance principle’ advantages?
What is the calibration procedure of Drum level transmitter if range is 0 to -400 mmh2o in lab?
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
How to convert mmWc(mili meter water colam) to tph(ton per hour)?
which processor is used in dcs.
what is gas metering system? gas chromatograph? and gas compressors?
What are the materials available to prepare individually for competetive exams in Instrumentation field? Plz reply...
In turbine what does term CDP, NH, HSSOC means.
the whole paper was based on Transducers..questions like define repeatability, error,accuracy,precision..den there were many q. on the conversion of Pa to mmHg and other units.. also..der wer few Q. on some level sensors(with diagram)
