which type of starter is suitable for single phase motor ?
- 11 Answers
- 14382 Views
- IOCL, I also Faced
- E-Mail Answers
Answer Posted / aayushi agarwal
1 phase motors are non self starting
so methods used for starting them are
resistance split
capacitance split a) capacitor start
b)capacitor start capacitor run
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
How to calculate the electrical load for a standard telecom BTS shelter and choose the DG set capacity for the same load?
How can we findout the maximum efficiancy of Transformer? At which load?
How would you calculate power loss in a resistor?
what is smart grid? why we use it? explain in detals bcoz i want give presentatin from it....
I am doing apprenticeship training at HT switch yard in NLC. How can i get electrical c license. ??? What r the rules for getting it as an apprentice? ??
how to find the torque of the single phase synchronous motor by doing an experiment
What is meant by reset level of the relay?
Explain using drawings what is reverse PID action w.r.t PID controllers.
what are different types of electrical windings? i know the distributed winding ,concentrated winding etc but i want some detailed information, in what condition we will use distributed,concentrated windings what are the difference between them which is best, how induced emf changes by using different types of windings 20 hours ago - 1 week left to answer
We have 90mX100m hangar with 16 no.of supporting pillar. It is required to provide power supply on all pillars. what is suggested earthing scheme for hangars.
What types of high speed CMOS circuits have you designed?
why current flow to the opposite direction of flow of electrons???????????
what is the formula for hv test for cable and circuit breaker..????
WHAT ARE THE DATAS REQUIRED FOR PROTECTION AND METERING AND CONTROL AND LOGIC PREPARATION,HOW TO STUDY THE PROTECTION AND METERING?
IF I KNOW THE AREA OF CROSS SECTION OFTHE WIRE , WATTAGE OF THE LOAD ,VOLTAGE SUPPLY WHAT IM GIVING TO THE LOAD AND ALSO POWER FACTOR OF LOAD ....... SO GIVE ME FOR WHAT AMOUNT OF CURRENT I SHOULD USE WHICH TYPE OF CABLE?
