Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / navdeep
friction between pen and paper
| Is This Answer Correct ? | 14 Yes | 32 No |
Post New Answer View All Answers
Locate nozzle in a turbocharger
If I can absorb 9,000 lux of sunlight in the bottom of a pool what will the temp rise be per hour, per square foot of absorbing material, per gallon be? Temp of pool deck 115 degrees, water temp 75 degrees, 120,000 lux on the pool deck
why do u ant to join the indian army??
2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand
plz send me paper of mppgcl 2008 or experience posted by any candidate
what's the difference between front and rear wheel drive?on what basis we choose the type of drive?
What are the different types of brakes?
What parameters to be reported when we send lubricating oil for shore analysis?
What is the importance of thermostat in the cooling system of an engine?
What happens when too much cylinder oil is injected in the working cylinder?
Why is over-pressurizing an air conditioning system bad?
Explain the terms solid solution, eutectic, eutectoid and peritectic.
What is the difference between isentropic process and throttlinglprocess ?
Explain the difference between afbc, bfbc, pfbc and pcfb in regard to fluidised bed technologies.
What is the mathed of maintain oxizen level in a air tite A/c room.
