Interested to Buy Any Domain ? << Click Here >> for more details...
What Should I Know about Metering, Switchgear and Panels?
- 2 Answers
- 5326 Views
- I also Faced
- E-Mail Answers
Answer Posted / sachinvom
The electrical power portion of most buildings will include
metering, switchgear and distribution panels. A
Construction Supervisor should have a basic understanding
of what these elements do. The metering allows the power
company to keep track of how much electricity gets used.
The largest amount of electricity used at one time (the
Demand) and the power factor also are important on
buildings that have more inductive loads like motors.
Then a main breaker will be required in the switchgear,
allowing the entire electrical system to be turned off.
From this main breaker, the current flows through circuit
breaker panels and sub-panels. Typically a one line diagram
shows the general concept of the electrical power system
and includes metering, switchgear and panels.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
what is the effect of back reactive power on the generator ?
What is VCB? where it is installed at SP. What is SP?
Why is better to have a minimum ceiling voltage of 250% than 160%?
3phase cable calculation formula by motor load
How to assume answer to electrical questions
Name the component u would expect to find in a switchgear assembly?
Why Water motor is not taking a load or pressure while everything is correct. (Note: Motor running properly)
what is the size of cable for 15kw motor and 85 meter cable length using with vfd
what is the thumb rule for determination resistance of resistor?
how can we change the phase angle b/w two phase?
If an electrical component has a positive temperature coefficient, how come such components have high power losses due to heat if current decreases when resistance increases? assuming power given by I^2*R whereby the Resistance is infinite.
How vfd saving power.
what is circuit breaker in transfomer and where it used
Usually in the L & T make MCC feeders' power circuit,we have BMR after the MAIN CONTACTOR.,can we interchange their position, keeping the control logic same???
can you send me the placement papers of electrical engg. from companis like NTPC,DRDO,IOCL,HPCL,BPCL etc.?If,plz send as soon as possible.Thanks.
