In a company has been installed an analog amperemeter, this
company was suplied by generator X, there is no problem in
the ampere meter, rigth now this company's supplied by
generator Y then the pointer in amperemeter vibrating. What
happened? Why?
Thank's
Answer Posted / bala
first check x and y same rating d.g if u say yes then check
ct details .and also check any sound varation in your d.g
set
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
what is the relative size of single and three phase?
Explain cos(theta) and Sin(theta)
how does a shunt reactor maintains the bus voltage???
Hi, Next week Iam appearing RRB exam for section engineer. So help me to get modal question papers for this position. Iam very thankful to you. Whether question will be fully techanical format or general form. Please give me a details regarding this exam.
whether starting current is limited to rated current of motor through soft starting or it exceeds the rated current?
Explain forward resistance, static resistance and dynamic resistance of a pn junction diode.
pls tell what are doing the three phase motor star and delta connetion with circuit diagram and control wiring .
What are the conditions to be satisfied for parallel operation of dc generators?
How to distinguish whether MCB is DC or AC looking at it physically
Draw the single line diagram of the power station?
If mutual flux is 1.2wb & power factor is 0.8 lag , then what is the Useful flux of a transformer?
What would cause a 240v choke that should give 110v out on a 16w lamp to gradually increase to 160v?
How do I calculate/select Droop CT ratio for various capacity of generators?
Ratings of power transformer,Distribution transformer.
What is the selection process of breakers. Can any one please give a formulation on same?