why we can't use more then 50 hz in india ? Is it possible ?
- 7 Answers
- 8759 Views
- DVC, I also Faced
- E-Mail Answers
Answer Posted / waqas ashraf
there are two standards
1)220v & 50hz
2)110 & 60hz
if we use 220 & 50: benefit is that we have high voltage &
low freq...disadvantage is that high voltage(220v) can cause
serious life damage risk.
&
if we use 110 & 60 :benefit is that we have less voltage as
compared to 220 but high voltage than 50 hz...
so life risk decrease in 2nd case...
| Is This Answer Correct ? | 1 Yes | 8 No |
Post New Answer View All Answers
define reflection method?
Why are short circuit ratings always 16kA,25kA,36kA and 50kA.Who has fixed these?
why we use Test Terminal Block in 11 KV and 33 KV electrical panels.
what is the function of gss in the dg set.
how will calculate the safe starting current of 3-phase squirrel cage induction motor?
What is the requirement of grounding the neutral of single phase generators on load? If the neutral is not grounded, what will be the effect?
a 230v transformer with step down ratio 19:1.it has 2000turns on primary and rated 25va calculate max primary current no of secondary turns volts/turn
What is distance between electrical panel to land ?
what is difference between line differential and transformer differential?
Transformer cores are laminated in order to A simplify its construction B minimize eddy current loss C reduce cost D reduce hysterisis loss
the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?
What is the Resposiblity of Electrical Utility Engineer
How to calculate multiplication factor in kva example 500kva ans pls ?
What is an automatic controller?
What is difference between Over Current & Earth Fault protection?
