Answer Posted / hamid (pdoc) inst tech
because the reverse valve it used for safty .in fail safe
condition it( NO) for safty perpose it use foe vent line
Is This Answer Correct ? | 2 Yes | 4 No |
Post New Answer View All Answers
How you calibrate absolute pressure with the calibration range of 0 to 1000 0C Absolute. Please explain the procedure for calibration.
POSSITIVE PULSE IS APPLIED TO AN INVERTER INPUT.THE TIME FROM THE LEADING EDGE OF THE INPUT TO THE LEADING EDGE OF THE OUTPUT IS 10 ns. THE TIME FROM THE TRAILING EDGE OF THE INPUT TO THE TRYLING EDGE OF THE OUTPUT IS 8 ns. WHAT ARE THE VALUES OF tPLH and tPHL?
Type of level transmitter commnly used in Procees area are the following. a.________________This type of level transmitter works as follows
What is defferent betwen ESP &PCP PUMP .HOW IT IS WORK?
field bus transmitter calibration procedure tell me
Calibration procedure for water rotameters
Explain bernoulli’s theorem. State its application.
Gas equation
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
What is surge and how is it prevented, what is the purpose of bypass valve across AS valve.
give me all the details about the interview and which type of question being asked
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
what is the difference between active & reactive power?
In dcs panel we are using diff type of modules ?what is module ? what is the use of modules ?diff type of module?
how to calibrate 0- 150 psi presure gauge by dead weght tester