Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / ravindraeee
dcs:(DCS) refers to a control system usually of a
manufacturing system, process or any kind of dynamic system,
in which the controller elements are not central in location
(like the brain) but are distributed throughout the system
with each component sub-system controlled by one or more
controllers. The entire system of controllers is connected
by networks for communication and monitoring.
DCS is a very broad term used in a variety of industries, to
monitor and control distributed equipment.
* Electrical power grids and electrical generation plants
* Environmental control systems
* Traffic signals
* radio signals
* Water management systems
* Oil refining plants
* Chemical plants
* Pharmaceutical manufacturing
plc:A programmable logic controller (PLC) or programmable
controller is a digital computer used for automation of
electromechanical processes, such as control of machinery on
factory assembly lines, amusement rides, or lighting
fixtures. PLCs are used in many industries and machines.
Unlike general-purpose computers, the PLC is designed for
multiple inputs and output arrangements, extended
temperature ranges, immunity to electrical noise, and
resistance to vibration and impact. Programs to control
machine operation are typically stored in battery-backed or
non-volatile memory. A PLC is an example of a real time
system since output results must be produced in response to
input conditions within a bounded time, otherwise unintended
operation will result.
so PLCs and PIDs&etc are the part of DCS and total system is
equipped with HMI and MMIs which are used monitor&control
the plant and to modifying the set point
| Is This Answer Correct ? | 9 Yes | 1 No |
Post New Answer View All Answers
why we use cascade control and feed forward control in 3 element drum level control measurement of steam drum .what is cascade and feed forward control system ?give example .
what is the difference between active & reactive power?
how to relay switch sense the fault?
where i can get training in INTOOLS and PDMS in Delhi-NCR OR north part of India. please reply with ur ans. at arunsamkaria@ymail.com
What is the constant voltage unit?
What is the use of GMV in turbine?
can we replace a slot sensor (inductive type) with limit switch (potenial free contact / no-nc type).
how 3 out of 2 Logic/interlocks works? give brief explanation with help of diagram.
what is the vital subject for scoring bhel exam&what is the question pattern
Make a ladder diagram on LSL valve will close, on PSL valve will open and start the motor
Explain PID, ON/OFF, Controls
i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....
-/5A. What is the meaning and limitations of this in energy meter constant. It is a 3 phase LT Energy Meter. If this Energy Meter is connected through a CT of ratio 200/5 Amps, then what is the multiplying constant and how its will be calculated.
Basically iam Instruemntation Engineer, but Iam interested in Instruments design engineering, so plz guide, is there any course, training or Softwres to become Instrument design engineer??.
Describe how to use megger to measure the earth resistance and insulation resistance
