Will a bulb glow if we connect it between the phase and
earth instead of earthed neutral?
- 3 Answers
- 8018 Views
- I also Faced
- E-Mail Answers
Answer Posted / ajai george
Yes it works ,I have even experimented by replacing neutral phase by earth point upon a failure of the neutral supply line.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
Is there any question in the name of Static Switch in UPS??
howmany electrician should maintain for a 1000 kva used plant... in kerala..
List of equipments required foe industrial repair lab.
why are u join ntpc
how to select the automotive wire size by mathematical calculation. for xenon headlamp with ballast. the ballast given data voltage 10-17v,current permenant 6amp, run up phase is 15amp, peak at swicth on max 400micro sec is 40amp.the sum of cable resistance is 150mohm.please provide referenc document if any for relating the peak at switch on current,time & wire wire size
what is difference between 9kv 5ka surge arrester and 9kv 10ka surge arrester.
How the over load setting for HT Motors calculated-provided in Numerical Relay
In Dyn11 power transformer if any one of the 3 phases connected to earth in star connected side then please explain effect of the current flow in delta connected side of transformer.(In this case if one phase is shorted to ground in star connected side then we observe the current flow in two phases only not three phases in delta connected primary side. Please explain why it is so?)
Why efficiency in thermal power plant is low?
sir i want previous entrance exam papers for written test
What do you mean by lighting transformer?
working principle a.v.r. ?
IF 8255 CONTROL WORD IS 94H,Tell the chip port work mode ?
WHAT R THE SAFETIES IN A HIGH TENSION PANEL N LOW TENSION PANEL. ALSO WAT SAFETIES R THERE IN A 200 KVA TRANSFORMER?
How to calulate Locked rotor amper(LRA) for compressor type motors?
