Interested to Buy Any Domain ? << Click Here >> for more details...
What is meant by Reactor in power system and what are the
uses?
- 11 Answers
- 51823 Views
- EEE, I also Faced
- E-Mail Answers
Answer Posted / paritosh singha
reactor is mainly used in high voltage long transmission
line (above 200km)to compensate the ferranti effect i.e to
minimise the capacitive effect.now a line should only have a
resistance in it.but due to long transmission capacitance
comes into effect.so to nullify it we add a specific
amount(say 50 mvr)of reactor in it.
| Is This Answer Correct ? | 46 Yes | 8 No |
Post New Answer View All Answers
What is minimum permicible value of leackage current for LT Panle when applying voltage up to 3 KV for 5 Minuits?
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING) I O (current operating)?
what is the difference between general inverter and solor inverter clerly explain plz
Why efficiency in thermal power plant is low?
what happened when we supply a dc current in dc motor?? can it worked properly?
What will happen if we on 200kvr capacitor bank(11kv in bus)If there is low load on transformer (1.5 mva 33/11 kv)
Write the analogous electrical elements in force voltage analogy for the elements of mechanical translational system.
What is the mechanism of WTI
with 3 phase board on a 63 amp rcd is it ok to have 6 electrical showers 2 on each phase and what problems could happen
What is a single phase autotransformer?
A ii kv 1200 A Breaker combination fixed in a cubicle. How many ampere Fuse is required? If fuse is not using, Why?
a battery is having capacity 100AH and 25% charging .if a load taking 10A & connected 6 hour .what is the final condition of the battery.
- two pumps must work with them at the same time but if the first pump start the second pump must delayed for some time to start also , with motor rated power = 90 KW and rated voltage = 380 V and rated power factor = 0.85 lag please draw the power and control circuit for it and determine all circuit components parameters that you use it
HOW WE KNOW IN PHYSICALLY THE CONTACT SURFACE OF A VACUUM INTERRUPTER IS GOOD OR GOING TO DAMAGE IN A VCB AFTER ABOVE 500 TIMES OPERATED.
How to minimize the eddy current losses?
