Answer Posted / r.praveen durai
Skin Effect only applicable to Alternating current.
The Alternating current concentration is High in the surface of the conductor and More while it gradually decreasing towards the center of the conductor.. may be zero value in center.The acceleration of electric charge produce electromagnetic radiation which cancels the current towards center.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Plz tell me how we can find that particular company has vacancy or not
what is cascade speed control device?and how this device control the speed of motors?
trasnfarmaer core make
1. The DC generaror,s induced output emf is connected with a DC motor(as load). when increasing the load of the motor by using brake drum or any way. what are the parameters will changes in both motor and generator(voltage, current, resistance, frequency, speed, torque, power, flux etc...) 2. Similarly for AC generator and AC motor 3. similarly if using DC batteries instead of DC generator, What happens?
After completing iti in electrician, how can i get certificate of electrical supervisor? What ia requirements. For it?
54 Comments Alok and Bhanu play the following min-max game. Given the expression N = 38 + X*(Y – Z) where X, Y and Z are variables representing single digits (0 to 9), Alok would like to maximize N while Bhanu would like to minimize it. Towards this end, Alok chooses a single digit number and Bhanu substitutes this for a variable of her choice (X, Y or Z). Alok then chooses the next value and Bhanu, the variable to substitute the value. Finally Alok proposes the value for the remaining variable. Assuming both play to their optimal strategies, the value of N at the end of the game would be?
To prove the capacity of a 10MVA transforemr with 6.5% impedance by a short circuit test how much power is needed to inject an impedance voltage if we have to arrive for its rated current?
What is the technical difference between On delay timer and a Star delta timer?
pls tell us AC plant are how do work and parts name with picture
how can i reduce sparking without stepdowning the voltage
what things to be considered when designing UPS
3- What is the target from Zero Impedance, Single Phase Imp., S/C Imp. and magnetic balance tests?
Is it possible to connect a safety device in to parallel?
Can we Co-ordinate relay in Load Break switch?
why should the primary of transformer be connected in delta in a heat run test?