what is differance between PLC system and DCS system
Proggramming.
Give me answer.
Thanks.
- 4 Answers
- 7963 Views
- UltraTech, I also Faced
- E-Mail Answers
Answer Posted / arumugam
PLC is a Controller in which used to operate the
mechanical or electrical components like water pump. For
example, If the water level goes low in the water tank, The
low level sensor give the signal to the PLC,then the PLC On
Commamnd singnal goes to Electrical panel to start the
water pump. It is called give and take command
DCS is device which is used to operate the mechanical or
electrical components through your PC. From the PLC HMI
Display controller, take the all command to DCS which is
programmed in your PC. So It is easy to identify or check
mechanical or electrical components running condition and
also it can be run the motor through DCS which you are
sitting in PC.
| Is This Answer Correct ? | 3 Yes | 3 No |
Post New Answer View All Answers
What is v/f control, sensor less control and sensored control for ac vfd?
What are the major disadvantages of product grouping?
ANY ONE USED/INTERFACED CITECT VERSION 6.0/1 OR 7.0/1 TO SIEMENS S7-300 OR S7-400 CONTROLLER IF PLEASE TELL ME THE COMMUNICATION STRUCTURE AND ADDRESS CONSIDERATION FOR DI,DO,AI,AO please mail the details lok_pallapolu@yahoo.com Ph:09247513753 hyderabad
formula for convert liter in to pale
if zero ohm is not adjusted on shorting the two terminal of multimeter what does it indicate
what is the standard time in production management ?
What is process analysis?
How does pressure transmitter electronics sensor be used to transmit level measurement parameter?
I have problem in APFC panel -0.44 while load ON time, i have replaced APFC display & checked the CT supply are ok. how to solve the problem
How do you estimate the fuel /diesel consumption for 125KVA DG Set?
What you know about iso 9001? What is quality management system? Weather qms is suitable, adequate and effective or not? Is there any quality policy? Is there any quality objective? If yes, then what are they? How they are planning to achieve quality objectives? Do they are measure quality objectives?
what is dc injection braking?
how to calculate area of a bar when you are getting weight per mitre of a tmt bar for calculating ps of that bar ?
Write a C++ code that print the largest two among three numbers
How to check DC Motor & SERVO Motor?
