Interested to Buy Any Domain ? << Click Here >> for more details...
what is meant by trip circuit supervision & directional or
non directional over current ?
- 1 Answers
- 5760 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
Trip circuit supervision is for supervision of trip circuit
for loss of DC supply,faults on trip coil or cables,faults
in auxiliary contacts and in itself, with breaker in any
position.Directional OCR acts for over current in one
direction only where non-directional acts for both the
directions
| Is This Answer Correct ? | 9 Yes | 1 No |
Post New Answer View All Answers
what is the chiller and working principal
what is the meaning of 5% droop or 7% droop in AVR?
What is the current carrying capacity of 35sq.mm flexible cable?
What is the most accurate way of testing ELCB?ELCB is better than RCD?
IF I KNOW THE AREA OF CROSS SECTION OFTHE WIRE , WATTAGE OF THE LOAD ,VOLTAGE SUPPLY WHAT IM GIVING TO THE LOAD AND ALSO POWER FACTOR OF LOAD ....... SO GIVE ME FOR WHAT AMOUNT OF CURRENT I SHOULD USE WHICH TYPE OF CABLE?
What is minimum permicible value of leackage current for LT Panle when applying voltage up to 3 KV for 5 Minuits?
Why is the frequency not changed during transformation of electrical energy in a transformer?
what is the diference between the 4pole & 6pole DC Motors & what is advantage 6pole over the 4pole ?
I have made a 3 phase thyristor full bridge rectifier. But at the moment it is working only for the half bridge operation. Both the half bridges are on operation separately but when i put it into full bridge operation the oscilloscope output is zero. I rechecked that the pulses are correct for each thyristor. what could be the possible reason for this?
state the working principle of incondenscent tube?
Can you any one explain application of buccholz relay operation and pressure relif device operation of power transformer
what is the power factor used by the PHCN in nigeria? 2. what is the difference between an alternator and generator. 3. Generation of poweris in KV but how is transmission is in MW. 4.If the transmission of power is 20,000MW how can it be increaesed to 80,000MW
what about SAP/MRP regarding manufacturing of electric motors and all drives?
why Lightning arrestor are made by 2 seperate stack of inslutor but why cvt are in single stack of insulator.
we have 15 ampere variyac but we want 30 ampere variyac what we do
