Interested to Buy Any Domain ? << Click Here >> for more details...
is it ok to switch lights from a mcb instead of switches
- 5 Answers
- 7723 Views
- I also Faced
- E-Mail Answers
Answer Posted / agrawal
u can but expensive
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is the significance of terminal voltage and phase sequence in the operation of paralleling of two generators?
what is interpose? where it is used and why it is used?
what is calculation mathod/formaulla for deciding Size of busbar (Copper/ aluminum)for L.T. panel on Various Fault level like 50kA,25kA,10kA
Whether 3 phase induction motorwith 100 hp capacity , Amp 160 for which sensitive earth fault relay , type CTUM 15 can be used?
What happen if we apply square wave or traiangular waveform voltage to the transformer primary winding instead of sinusoidal wave?
hey guys help me out.....what are the industrial uses/functions of nozzles in industries
IN SINGLE PH TRANSFORMER IF LEKAGE IMPEDANCE DROP IS NEGLECTED ,THE FLUX IN THE MAGNETIC CORE and the lekage flux linking a winding are a)proportional to the applied v to the winding i respectively.
kVA rating of ordinary transformer is increased when connected as an auto transformer because A transformation ratio increased B secondary voltage increased C energy is transferred both inductively and conductively D secondary current increased
I have a relay contact rated at 220v dc which is supplied with a 24vdc from the panel,for it to trip the dampers(24vdc).What if the application of the relay changes so that it should work at its rated 220vdc then will it work at 24vdc supply given or any other consideration needs to be taken .....
What are the relays in ACB and VCB
What is the differentional relay...what is the work of this in power Tx. how it is works..
does the Trivector Meter of three phase automatically takes care of the low power factor and gives the reading accordigly or it does not take care of the Power factor while giving the readings please explain
limitation of conductor height on ground when we consider EMC
what is the effect of un-synchronized power.
We have a couple of oil tanks at our plant. One of them does not have a lightning arrester installed. My question is it necessary to install an arrestor on every tank or will this particular one be covered by the arrestor installed on the ajdacent tank, Since all the tanks are close to each other. Basically, I want to know that if these arrestors or protection works in a parituclar area of effect or influence. Thanks
