Interested to Buy Any Domain ? << Click Here >> for more details...
AC voltage only create magnetic flux in coils, but in Solenoid
coil how 24V DC volt create flux and pick the plunger
- 5 Answers
- 12275 Views
- I also Faced
- E-Mail Answers
Answer Posted / shivam
DUDE IN CASE OF TALKIN ABT FIELD IN COILS, just think abt
the poles generated on the 2 faces of the coil. one becomes
the north pole n other as south. ok , so due to attraction
b/w the pole n plunger , it gets picked up.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
how to calculate single phase motor efficiency ?
how to check avr of dg set of 125kva
why do motors burn out? I understand why adding parallel loads to a power source means more current moves through the circuit, and can destroy circuit elements by overheating. What about when you have a vaccuum cleaner intake flush against a floor, a room fan sitting directly against a wall, or a power drill trying to drill through something too hard?
What is the rate of WCT on the Electrical Contracts comprising of DG Sets and Civil Works in Delhi ?
regarding safety what would u consider the most important rules to observe when inspecting electrical equipment?
how to check ac servo motor
What would cause a 240v choke that should give 110v out on a 16w lamp to gradually increase to 160v?
Define active filter?
What information we need to prepare relay coordination chart
Briefly describe your ideal job?
it is possible to rotate the DG engine dc starter with wrong polarity connections? why?
Different types of relay fault which phase sequence??
How npn and pnp transistor works
A 7 storey building has a floor area of 35,000sq.ft on each storey. On the ground floor 11KV electrical sub-station is to be erected. A load of 3kw for every 400sq.ft (p.f is 0.8) is proposed for each floor. fire pump 7.5hp, water pump 5hp, lift 2 nos, each 10hp and 20shop load of each shop is 5kw. calculate a. load each floor b. total load of building c. L.T feeders for aech floor and from transformer to main. d. distribution diagram e. capacity of sub-station/capacitor bank f. line diagram
How to calculate of maximum demand if given 628kw, 785kva, 0.8 p.f.
