Answer Posted / md.abdul majeed
IN PLC(PROGRAMMABLE AND LOGIC CONTROLLER)ONLY FEW ANALOG
SIGNAL ARE TESTED,WHERE ELSE USING DCS(DISTRIBUTED CONTROL
SYSTEM)WE CAN TEST MORE AND MORE ANALOG SIGNALS.
| Is This Answer Correct ? | 3 Yes | 8 No |
Post New Answer View All Answers
What is stripper & spilitter ? Diffrence in this.?
how to connect transmitter measuring sulfur process? 1-by using long impulse line or 2- by using coated short impulse line
please send the sample qustion paper for iocl written test ..
why use 50% lel methane gas concentration for gas detector calibration instead of 60% lel gas concentration whereas the hi alarm set at 60% lel.
what is the input of digital counter during the the calibration time?
we have a s-5 simense plc having op7 .recently on op7 showing error 1.plc not present 2. DB error frequently. can u have any solution . please send me.
What is the Working principle of Dozing valve?
If fire would be inside the plant which fire detector is to detected the fire.
why orfice is not used for main steam flow calculation
Hi Friends i am going to write BARC written test by this month 20th (20-5-2008). So please if any body knows the details about this or having previous question papers pls mail me to kkumarei@gmail.com. For Suggestions give one message to 9962122264
Using your own examples solve a problem involving normal table. (experimental method and analysis)
how to design orifice plate?what is the equation?
please send me the inteview questions in IOCL
What are the charcterstics of a P&ID controller block for Governor speed raise or lower for a load sharing functionality between 4 Gas turbines in droop mode.
can any send me a forbes marshall dtron 316 manual
