Interested to Buy Any Domain ? << Click Here >> for more details...
Hi,
I'd like to know the purpose of MOS (maintenance override
switch). At site, these switches are installed in a
stanchion with the transmitter (connected to ESD). thank
you.
- 3 Answers
- 36005 Views
- Adani, Adani Wilmar, I also Faced
- E-Mail Answers
Answer Posted / wael salah
maintenance override function is used for bypassing shutdown
processing so that it is not executed by safety logic during
partial maintenance such as specific input.Creating bypass
logic using a dedicated override allows the (HIS) to safely
perform maintenance override for SCS (system control station)
However Maintenance override can not executed from the HIS
unless this switch is in the permission status.
| Is This Answer Correct ? | 22 Yes | 0 No |
Post New Answer View All Answers
can we replace a slot sensor (inductive type) with limit switch (potenial free contact / no-nc type).
What is the use of each wire in three wire RTD
how can i calibrate the temperatuture gauge used by temperature bath(dry block) i mean step by step procedure?
kindly sent some demo question and answer
If P will increase then what will happen with PID?
What is the difference bitween control net scaner and device net scaner
Which products are available in the Mass Systemswitch and System Manager AC range?
Dear Sir/Madam,im going to attend Hpcl written exams on feb 17th in instrumentation stream..can anyone send me the HPCL model papers and pattern of HPCL ....i ve not yet attended anything in HPCL...so i dont know how it comes...so just i need some model test papers and pattern ..pls help me friends...
Why all the drains(Gland sealing,ESV,Casing inlet etc) are directly connected to the flash tank instead of hotwell of the condensor in the power plant? My Email Id:naba02222@gmail.com
What is the PLC configuration in Cement industry?
control panel design guidelines
dear friends, i have seen flow as the selection critriea in presure guage (bourdon tube) and i would like to know what is the relation between flow and performance of pressure guage other parameters i found in the data sheet are pressure max. 1ksc temperature max. - 50 deg c line size - 80NB operating range - 1ksc pr. guage range - 0-2 ksc thank u,
How many interlocks at turbine side?
Why grounding is necessary? Give example with diagram.
for oil & gas industries which zone is normally preferred? why? give its example?
