Interested to Buy Any Domain ? << Click Here >> for more details...
hi engineers,if suppose distribution is going to two diff
village mistakenly they r interchange the neutral of twowhat
happen?
- 7 Answers
- 11971 Views
- Bhel, L&T, I also Faced
- E-Mail Answers
Answer Posted / vipul bhavsar
In distribution if neutral interchanged but both is healthy
nothing happened,in case one neutral got loosed or opened
than unbalanced voltage will be induced in each phase and
it may be in KV for Milli sec. also so will fused electronic
component also, you also hear that due to GEB high voltage
television got fused this happen due to neutral shifting.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Haw to check conductivity of budbar
As per the Anchor capstan motor specification, full load current is 200A. starting current is 1750 A and acceleration time is less than 8 seconds. Please guide for selection of cable size.
iam preparing for rrb section engineer post in electrical branch.suggest the right textbook for my reference.fromwhere i will get the previous q.papers?
how load of a turbo generator can be increased
Is better to supply the voltage for static exciter from the auxiliary power source or from the SG terminals? And why?
in my industry we are using 3 step up transformers for induction heaters..i.e 415/580v and other are 11/440v.in power consumption does a step trnsformer makes any difference compared to step up?? plz explain
What is warm / cold start of HT motors. How many warm start & cold start are possible in a day?
How to check the thermocouple is correctly connected to cable for K type? (i,e positive pole is connected to non magnetic conductor and negative pole is connected to magnetic conductor)
i karmveer bharti persuing b.tech . plz send me syllabus and name of reference books. for preparation of section eng.
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
What was your role in the silicon evaluation/product ramp? What tools did you use?
HOW TO CALCULATE AMPs OF CURRENT TRANSFORMER IN HT Panel
I am EEE student i want to improve my core side skills.how cn i approach it?
What is the importance of earthing?
From past few months I am getting lagging pf even though sufficient capacitors used in circuit. Where is the problem pls answer
