Answer Posted / sibapati acharya
Despite the type(which is dependent on frequncy range of
flame),the basic principle is that a concave lens is used
for directing the flame rays to a photo diode. the current
produced from the photo doide is condtioned for flame
detecting in BMS.
| Is This Answer Correct ? | 10 Yes | 2 No |
Post New Answer View All Answers
What is the procedure of calibration of Load cell?
what is function of sensor, and how is it work , explain with difination
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
how can use ram
WHY THE DEGREE OF VALVE PLUG AND VALVE SEAT IS SLIGTLY DIFFERENT I CONTROL VALVE TRIM DESIGN
Name different parts of a pressure gauge.
my data card only does run in my mobile so how can change it that it run other mobile & computer and i can stor data in my data card
why use 50% lel methane gas concentration for gas detector calibration instead of 60% lel gas concentration whereas the hi alarm set at 60% lel.
Explain the combusion chamber
How signals can be taken through modbus?
Actual using of tube bender to bend 2 opposite 90 deg at correct measurement center to center of tubing.
HOW CREATED LP & HP PRESURES IN DRUM FOR DRUM LEVEL MEASUREMENT!
What is hp & mp seperator .& what is its working principle ?
any body please send me the old question papers of ongc test.
What is the difference between mmwc and mmwg?
