CAN ANYBODY EXPLAIN WHAT ACTUALLY MEAN BY THE PHASE
DEFFRENCE? R,L,C CIRCUITS?
- 5 Answers
- 6080 Views
- I also Faced
- E-Mail Answers
Answer Posted / nagaachi
ITS ME THE QUESTIAN IS ASKED,
In my concept the voltage is applied to a pure Resistor the
current developed with respect to the Voltage & Resistance.
So it is said to be inphase
in case of Inductor it wiil opposes the every
attempt to develope a current because of self induced emf.
So it is said to be lags.
The real conflict is with the Capacitor in which
current leads the voltage.
""DOES IT MEAN THE CURRENT BEFORE APPLICATION OF AVOLTAGE?""
can anybody answer it
nagaachi
INDIA
nagaachi@gmail.com
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what are factors comes under relay setting (distance relay 7sa52) under OPEN DELTA VTs connection??
HOW DO I CALCULATE THE SETTINGS FOR THE DIFFERENTIAL PROTECTION OF A 12kV/6.6kV, 6MVA,DYN11 XMER WITH PRIMARY SIDE CTR 400/1 AND SEC SIDE CTR 600/1?
A 11KV, 1200 A breaker combination fixed in a cubicle for HT motor.Is normally for 11 KV motor fuse is using? if Yes, What range fuse is required?
sir, what is the importance of Fault MVA. how to calculate fault mva of 33kv substation connected by 6.5 km line(single circuit with equal spacing) with 110/11kv transformer in 110kv susbstation.the fault mva on 11 kv bus in 110kv susbstation is 208mva.
what does a k rating in a transformer means?
when the time of backcharging the transformer three phases only enough or three phase with neutral is must.from these which one is the best one.
previous year paper of ntpc bhel for degree in electrical enng
Why magnetic flux produces an induced current?? what is the detailed procedure ?? ans plz
During Testing of Maintenance Free Earthing, How deep should be the Spikes of Earth Test Meter should be inserted in the soil(one spike is 15 Meter & Other spike is 30 Mtrs away from the Main Earth Electrode. Because, recently, we observed that when spike is inserted 3-4 Inch in the earth- results are better, If spike is inserted 1 feet deep than results are increasing.
Define conversion efficiency of a power amplifier.
In a voltage-controlled current source A A current booster is never used B The load is always floated C A stiff current source drives the load D The load current equals Isc
dg started in plc mode and load taken later one battery terminal connection will be disconnected by loose connection what will happen for dg and shall we connect battery terminals while dg in load time?
What is the working mechanism of OLTC in Power Transformers????
what is the stear deltaprinceple?
what will happen if there is a voltage leakage or current leakage in an electrical train
