Interested to Buy Any Domain ? << Click Here >> for more details...
if we give connection of 100watts bulb through a single
phase energy meter ,the disc of a meter rotates why it
happens?
- 1 Answers
- 3068 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
Because it is recording consumption of electrical energy
| Is This Answer Correct ? | 2 Yes | 3 No |
Post New Answer View All Answers
internally connection of photvoltic module
Both generator parallel condition shared load equally but one genrator taking ampere more than the other what are all the causes to make like this
In the Variable Voltage Variable Frequency Drive, how the Voltage and Frequency varied ? Is it varied in the Inverter part of the Drive ? Please give us supporting document if any.
Can you used moeller lzm1 mccb in a dc system with 125vdc and 20ka short circuit current , beside is it have 24 or 48 volt shunt ? Beside how long current can through from An MCB shunt contacts? (like Z7-AS 24 V)?
what is size of 3phase 4wire cable to be used for 11 ton ductable A.C and how to calculate cable size for different load
What happened when capacitor connect series in ac circuit?
How does a transformer contribute towards the widespread popularity of ac system over dc?
Explain the experiment on ward leonard method of a speed control on a dc shunt motor with an suitable circuit diagram.
What will happen to the protection and metering, if the polarity of a single or two PT/PTs in three phase system is reversed? Please provide reference if any.
Why frame of the motor is specified?. If we mention KW and voltage level,automatically frame is decided or separately frame is compulsory to mention?.
What is the formula to calculate a three phase alternator
wat is the first thing dat is needed, 2 lay a cable in some area??
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
what & how to check the lightning arrester
Dear sir, By which formula u can calculate for a particular kv line there is a range of mw.
