Interested to Buy Any Domain ? << Click Here >> for more details...
I have seen the Temperature element (T/C & RTD) installed
in process line on 45 degree position, Why? What it mean?
How many types of tapping position for temperature elements?
- 4 Answers
- 11797 Views
- I also Faced
- E-Mail Answers
Answer Posted / anil patil
when we installed it straight (90degree)the sensor may not
touch the media properly ,but at 45degree sensor can touch
easily and we can installed more sensors length in pipe by
this angle.
| Is This Answer Correct ? | 6 Yes | 2 No |
Post New Answer View All Answers
What is heating effect?
what step is taken for ESD ( emergency shut down) in DCS REPLY to hashimka20009@gmail.com
How u measure the massflow in orifice flow measurement techniques
How to calibrate RC Feeder system in thermal power station?,If any instrument available to calibrate it,ple inform me. make:stock,
Tell about your IFFCO plant visit.
What is modbus?
draw the block diagram of a level transmitter ?
How to erection of DCS Panel at site step by step
How flow can be measured with dp?
How to convert Differential pressure to flow in TPH
Tell me the field calibration procedure step by step with diagram of pressure gauge, pressure switch, pressure transmitter, temperature switch, level switch, flow switch, flow transmitter.
can u plz send me technical questions asked in SCHNEIDER ELECTRICAL technical paper?
Which tank weighing system is better to install (Accuracy point of view) 1) Tank weighing system with 3 load cell or 2) Tank weighing system with 4 Load cell
Coal mill Instruments Equipments for cement plant And process diagram ?
Dear Friends, we are planning to design Power distribution and Fiber optic in the same cabinet.Like Front side Fiber optic and Rear side Power distribution.Is it any possibility of problem occurs like interference etc? Your answer is highly appreciate.
