Answer Posted / k.prakashchandra
current capacity of copper can be taken as 2.5 A/sq mm but
for generators it is taken as 1.5 A/sq mm.For duration of
less than 4 hours 6A/sq mm
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
ACB & VCB how do work and saftes and how can maintenance in this and parts name show with picture
the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
IN SINGLE PH TRANSFORMER IF LEKAGE IMPEDANCE DROP IS NEGLECTED ,THE FLUX IN THE MAGNETIC CORE and the lekage flux linking a winding are a)proportional to the applied v to the winding i respectively.
what is relation between ct and pt ratio with multiplication factor of a energy meter? is there any other factor on which multification factor depend?
WHY RATING OF VCB NOT LESS THAN 630A
What is the basis for framing the rules of block diagram reduction technique?
Can a generator runs after getting 1st stator earth fault.
Draw a SLD of HT distribution EB grid up to users Transformer?
hi i have applied for lic of india south cenrtal zonal ,hyd. i didnt get hall ticket till now.let me know how can i get form internet
whit is 33kv power 300*300 cable full current with formula
If we need4× 50mm sq cable but it's not available so we can pull 4×25mm sq 2cables
The 3 phase 400 hp 440 volt slip ring induction motor do not take one phase amps why ? The motor is running good condition
What do you mean by per capita requirement of electrical energy in india
What is the meaning of floating point earthing in battery backed systems ?