Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / pranav upadhyay
Current is a flow of electron which flows from higher potential to lower potential.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Why is better to have a minimum ceiling voltage of 250% than 160%?
if two transformers are placed parallel & both have fault impedance of 50KA will it increase or decrease show example?
What is the typical enclosure type used for Indoor switchgear / Outdoor switchgear Units? - In Onshore / offshore Units?
How you calculating the 30 Hp 3 phase AC motor of power what size of cable is used for this motor?
what happen if the load connected to the induction motor is taken away? the same question for synchoronous generator in synch i think that the the exitation voltage will appear on the terminal only if so plz answer me
Define noise?
why do you add the load short circuit impedance when considering short circuit amperage. It seems that you should only consider supply. If you need to consider loads and you don't know what loads are to be added , what would be a good sub-transient reactance rating for the loads?
Why saturation region slowly shifted in the left side?
Is RTCC panel needs any control supply.
what is the principle of operation of tungstun bulb ??
why we can stote dc? why we cant store ac?
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
i m in need of current rating chart of heavy duty pvc/xlpe, cu/al cables. can somebody provide me? if yes, plz send me at ashish_patel111@yahoo.com
what is the reqirred voltage in HT motor to get full RPM on no load test?
How Can You Relate Power Engineering With Electrical Engineering?
