WHY CURRENT DECREASES WHEN VOLTAGE IS INCREASED IN A CURRENT
TRANSFORMER ?
- 5 Answers
- 9652 Views
- Sterling Wilson, I also Faced
- E-Mail Answers
Answer Posted / jax
Question is wrong.
| Is This Answer Correct ? | 3 Yes | 4 No |
Post New Answer View All Answers
HOW TO CALCULATE HV TEST VOLTAGE FOR ELECTRICAL EQPT.
Why does the adjacent zone of protection overlap?
I need bhel previous year quetion papers for electrical engineering department.I searched but i could not find out
why the earth is taken minimum in supplying? wather it the proportional factor to getting work any equipment or a power plant?
explain why core loss of a transformer is almost constant under different load conditions when connected across a constant voltage and constant frequency.
If more than rated DC voltage appears across trip coil of the breaker, what will happen? e.g. in 110V DC circuit system, if voltage across battery terminal showing 121 V
can we use ZNyn11 transformer instead of Dyn11 transformer in distribution for effectively eliminating harmonics from the industrial loads.
can you send me the placement papers of electrical engg. from companis like NTPC,DRDO,IOCL,HPCL,BPCL etc.?If,plz send as soon as possible.Thanks.
Why do we need a separate control desk & PLC control panel in Boiler plant or coal handling plant? Can we provide cost effective Control desk cum PLC panel. Is there is an specific need for control desk.. kindly advice.
What effect does a very low impedance have on the Voltage regulation? On the short-circuit current?
2 v/500amp/hr to 1.80vpc at 20 degree celsious 2v/5ooamp/hr to 1.75 vpc at 77degree farren .this is the capacity of a battery .what is the meaning of this . can i get a detailed explenation
how to find the torque of the single phase synchronous motor by doing an experiment
What is expention fastener (Fan)
how synchronous condenser is used in place of synchronous generator with out negotiating IEEE standards? Can i use 3 generators as synchronous generators and 2 generators as a synchronous condensers in an IEEE 14 bus system with out disturbing the standards?
What are the advantages and disadvantages of open loop control system?
