Interested to Buy Any Domain ? << Click Here >> for more details...
what is the ideal earth resistance
- 11 Answers
- 23102 Views
- Amit Enterprises, Enercon, I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
Ideal earth resistance is zero, which is almost
impossible.The recommended max values in ohms for stations
are 1.33KV-5 2.66-2 3.110 to 400 KV -1.0 4.generating-0.5
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
I want to know Electrical Circuit?
why we change the direction of winding in rotor ?how we make the north and south pole?
Refernce currents are to be generated using refernce cueernts how can this be done
what will happen if frequency is below 50 hz?
EXPLAIN THE TRANSFORMER MAINTENANCE?
what should be the ideal gauge of wire (In sq mm) for different loads in Ampere?
whatare the disadvantages occur,if the form factor of transmission will not be equal to 1.11
why dc is used in control circuit for mv & hv switchgear instead of ac
How do I calculate/select Droop CT ratio for various capacity of generators?
What is routh hurwitz stability criterion?
When calculating the speed of a rotor required for a particular frequency of synchronous generator we use the equation 60f/p Is this p is the number of pole pairs of rotor & do we consider the number of pole pairs in the stator is 1?
we have two generators different capacity on 15 MW and other 6MW at 11 KV , 15 MW gen. bus short level current 40KA,and 6MW short level current 25KA,, length of cable 100MTR between 6 MW from 15MW gen. for bus coupling . kindly tell any one can we use both NGR OR one NGR from any GEN. BOTH NGR has diff. rating. Tariq pakistan
in a solar power plant,we are going to step up the voltage 350V to 33kv, and to 132kv GSS. i want to ask that if it is possible that 315v/33kv is not possible because we also use 315v/11kv. or it should be 415v/33kv? is it effects generation or losses? the second question is-generation is depends on LV winding? or LV winding design for generation voltage?
at what rate the micro controller increment its timer....is it 1micro seconds or 1/(12*10^6) seconds
What is Tachometer used to measure?
