Interested to Buy Any Domain ? << Click Here >> for more details...
difference between earthing and grounding?
- 2 Answers
- 7208 Views
- ABB, Bharti, L&T, I also Faced
- E-Mail Answers
Answer Posted / hareesh
connecting neutral point of a 3phase system to ground is
earhing.connecting body of an equipment to ground is
grounding.but,normally both words are consider eqully.
| Is This Answer Correct ? | 21 Yes | 5 No |
Post New Answer View All Answers
what is Different between Bilinear and Unilenier?
I have 440v power coming to facility,( not being used ) can I buy large generator, (gas) to sell power back to electrical co.
Currently what is the highest capacity (MVA) of SPPg generator available in the market?
How is operate breaker failure scheme in substation
ii) A shunt motor supplied at 230V, runs at 900 rpm when the current is 30A. The resistance of the armature is 0.4 ohms. Calculate the resistance required in series with the armature to reduce the speed to 600 rpm, assuming that the armature current is then 20A. [12]
WHAT IS THE CURRENT CARRYING CAPACITY OF 2.5/3 CORE HI TUFF CABLE,WILL IT SAFLEY CARRY 8.6 AMPS OVER 120 METRES,CAN YOU ALSO ANSWER WITH FORMULA FOR WORKINGS OUT ,THANK YOU 3RDYR APPRENTICE.
Name two types of electrical analogous for mechanical system.
explain PV modules in solar energy generation.
the winding of Generator and Motor is star or in delta ? and why
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
pls tell what are doing the three phase motor star and delta connetion with circuit diagram and control wiring .
difference between a diode and thyristor?
What is state space method ? Why its used ? Can it applicable on linear, non-linear, 1st order, higher order, homogeneous, non-homogeneous, open-loop , closed loops , stable & unstable systems ?
I meggared my 2c*70 sq mm AL AR XLPE cable. its one end show 50 M ohm . is my cable is safe for laying. I have only one phase and neutral.
Dear sirs, pls check this 4-20ma to RS485 module datasheet,pls guve me some suggestions. http://www.szsunyuan.com/sy/pro_more.asp?Productid=539 Thanks. E-mail:yunianjiang99@gmail.com
