Interested to Buy Any Domain ? << Click Here >> for more details...
what is the Analog signal and what is the Digital signal
- 4 Answers
- 7879 Views
- I also Faced
- E-Mail Answers
Answer Posted / s.jayaram
Digital signal is nothing but voltage state is 1 or 0
whereas Analog signal is voltage, current, frequency varies.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
What is defferent betwen ESP &PCP PUMP .HOW IT IS WORK?
can we replace a slot sensor (inductive type) with limit switch (potenial free contact / no-nc type).
can we create an interrupt in plc through scada?
Q- What are the application in which PNP transistor is preferred over NPN ?
Who to difference between analog in & analog out in dcs?
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72
What are advantages and disadvantage of the ac supply load cell?
how to calculate the total flow in square root
If i have 4 Allen Bradely make RS logix 5000 PLC and for viewing that we are using 4 RS view SCADA for 4 different packages. Now, I will want to view two packages on only one SCADA. Then how i will do it?
hi my name is rakesh patel i just complited my be in instrumentation & control now i am going to working as a validation engineer in a poject department so what is a scope in a future as a validation engginer ? what line is good for me can any bady give me complete solution please? your regard rakesh patel
what is loop1 and loop2 in MTS LT?
Conversions
Is there any relation between Artificial Intelligence and Instrumentation?
why fuse block is not used for AI signal?
when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??
