whats the one main difference between UPS & inverter ?
And electrical engineering & electronics engineering ?
Answer Posted / n. v. harikumar
UPS is the equipment for providing an uninterrupted power
supply to the load but inverter is for converting the DC
supply to AC supply at a constant voltage irrespective of
input voltage.Generally UPS is connectine in parallei to
the load or the load may be through UPS to avoid cutting
off the supply when an interruption in the source of
power.Generally UPS is a system having a battery and an
inverter. Battery will feed DC power to the inverter and it
convert the DC into a constant AC out put.
Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
How calculated single phase induction motor req. Capacitor?
If o/p power is doubled by how much does the sound increase
If a shunt Dynamo has induced emf 100V and 0.4 ohm resistance and battery of accumulator of open circuit emf 110V and 0.5 Ohm resistance are in parallel what is common terminal potential difference?
How to check the thermocouple is correctly connected to cable for K type? (i,e positive pole is connected to non magnetic conductor and negative pole is connected to magnetic conductor)
what reactive how to maintain
what is laser diodes?
What is the exact formula for one weber of magnetic flux?
How to calculate approximate load loss of a distribution transformer by knowing %ge imp of transformer?
To prove the capacity of a 10MVA transforemr with 6.5% impedance by a short circuit test how much power is needed to inject an impedance voltage if we have to arrive for its rated current?
Hi, My plant daily consumption is calculated as 3.8MWH but my supplier has sanctioned an power of 2.6MW per day. how can i equal or distinguish this two factors
Explain the iniluencc of short circuit ratio on the pert'orniancc of synchronous machine.
What is bridge rectifier and explain with details
Can anyone provide with a SLD for HT panel installation for a 33KV line and distribution end has three 1.5MV transformers. Is it suitable to use OCB or VCB and also provide me the suitable rating and its connection diagram.
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The slip when motor stalls is A 1 B 0 C 13.33% D 10.33%
how withstand of hi-pot test outputs of transformer wire 2.5mm