Interested to Buy Any Domain ? << Click Here >> for more details...
If you see the HRC fuse name plate. Its shown ampere rating
shown which is in many KA (like 80KA and so on). any body
explain what is meaning of this value?
- 7 Answers
- 18861 Views
- I also Faced
- E-Mail Answers
Answer Posted / william lobo
I understand your predicament. But you will only have to
see the 100A which is written in your case and this is the
capacity of the fuse.
80KA is the rupturing capacity of the fuse which is not for
you but for system designers who want to know these things.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
what is the IEC standard for Power Cable installation in onshore (like in direct buried ground or above groung)
What is electrical cable termination
At full load wat is the motor p.f And at no load will is the motor p.f?
what will happens if one phase is missing for 33/11kv power transfomer and why?
what are all the components required to assemble solar panel other than pv cell?
hii this is ranjith from hyd... i want to know what type of questions they ask in interview...and hw the interview will go..? what subjects thay ask specially for electrical engg students?
what is the relationship between current&voltage in practical purpose ?
The power supplied to a 50mH inductor from a 120V, 60Hz source will be
how to calculate the fault in substation
How convergengr of nr method is not dependent on selection of slack bus and how gauss siedel method depends?
ITI r/tv trade APPLY (J.T.O VACANCEY) ALSO INCLUD AITT ELECTRONIC,WRITEEN XAM DONE 23.03.10 BUT NO RESPONCE WHY ANATHER ID gopal_gh007@rediffmail.com
hi I have done 3 yrs diploma in electrical engg after 10+2. I have 16 years of work experience into design proposals sales and engg application development in LV/MV swithcgear and sub station automation field. I want to apply for immigration to new zealand but I am not sure whether I qualify or not since I dont have a degree. Can anyone advice? Thanks Riz
How is operate breaker failure scheme in substation
where the lexical paramater will use in fron end?
what is power factor ? how we can calculate the low power factor and amount of capacitor for improve that low factor ?
