Interested to Buy Any Domain ? << Click Here >> for more details...
What will Happened if the polarity of CT is changed?
- 13 Answers
- 41207 Views
- I also Faced
- E-Mail Answers
Answer Posted / sunil pund
Ammeter showing the reverse direction
| Is This Answer Correct ? | 2 Yes | 6 No |
Post New Answer View All Answers
what is a bus post insulator? explain its application in a substation.
If we want to change a contactor of faulty one what are the conditions want to fullfil
please write motor, transformer, Generator setting, fault level calculation of Tr.etc
What is meant by control system?
what is the VA(Volt-amphere)? define with calculation?
Hi friends, i m electrical engineer i want a cdr for migration purpose so anybody have information about this then send me on jayesh_ee88@yahoo.com.please try to me
why in the three pin plug all 3 pins are cutted ?
how do we calculate length of starting time and repeated starting of a direct online starter?
define the non synchoronism of synchoronous machine in general g or m??
Explain the laying procedure and laying depth of submarine/subsea power cable for 220/400KV system? Also available cable diameter?
We have 250 KW x 2 motors, which are load from 25% to 100% varying load in every minute , so how can we compansate the power factor. pl give your opinions on the above subject.
what is the effect of higher value of GD???
How we can recongnise the phase displacement of transformer connection between primary & scondary...plzzz explain it with example.........
When we use air circuit breaker, it has O/L protection ,time delay SC protection, Instataneous SC protection & ground fault protection. They all have some setting range. But what is the suitable/allowable setting for the above protection which will be safe for the equipment? For example-O/L protection setting have a range of (0.4,0.45,0.5,0.55,0.6,0.65,0.7,0.8,0.9,1.0)xIn Time delay SC protection have a range of (1.25,1.5,2,3,4,6,8,10,12)xIn Time delay setting is 0.02,0.1,0.2,0.3,0.4 Instataneous setting is fixed to 20xIn Gound fault setting is given 100A,300A,600A,900A,1200A This setting are for 2500A ACB. So what will be the basic allowable setting for the above protection? is there any formulae to calculate this<
why constant voltage transformer should be start without load? and if started then what will happen?
