Interested to Buy Any Domain ? << Click Here >> for more details...
Is there any option to replace two Genset of capacity 125KVA
with one higher capacity for same office?
- 8 Answers
- 9570 Views
- I also Faced
- E-Mail Answers
Answer Posted / kpd
There are not enough details given here to give an
approriate answer.
Office back-up generators are renowned for being crammed in
to the last bit of space the facility has left. Airflows
have to be considered for cooling and also attenuation for
a larger generator is larger again causing prospective
space issues.
Economic constraints may also exist, re cabling a single
feed to the office main board in larger cable to accomodate
the single larger generator may cause issues. Also the
operating logic of any changover contactors or equipment
will massively effect the generator choice.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
In siemens S7-300 PLC, what is function and function block ? What is the difference between them ? When to use function and when to use function block ?
How to Preparation of online test
Why r u using pf panel. what the uses
where we use the SFU & FSU?
Starting current of a 10 HP induction Motor is ______ time’s full load current.
what percent do you derate your copper wire when you change from copper buss to copper wire
I just purchased a 4 position cam switch to be used to operate a 3-speed blower motor. The motor is a 10 amp motor and has 3 wires that are used to control speed. The cam switch was rated at 660V 20 amps but when I received it, I noticed that it has AC-15 operational current rating (Ie) of 4/5 amps. If I am reading the label correctly. the 4/5 amps is related to 440v/220V (Ue). Other ratings are AC-3: 5.5A, AC2: 7.5A and AC-4: 1.5A. My questions are 1) Is it safe to use this switch with the motor I have 2) what is the difference between the 20 amp Ith ratting and the Ie operational ratings?
Draw the line diagram of diffretial relay connected to transformer?
Why strting torqe high in inducation motor?
can anybody tell me that for p.f. Improvment we use capacitor banks but how to decide its capacitance. As we all know how to calculate kvar but what abt capacitance value
what are your career plans upon completion of the programme and the relevance of recity generation to your professional development?
in electrical control panel. how can i choose the cable rating. (example - 11kw motor, 18-25A mpcb}
what is the effect of connecting three phase supply lines to three phase auto transformer output terminals through a fuse of 10Amp and a circuit breaker (MCB). Is this connection permanently destroy the transformer?
What is meant by impedance? difference between high & low impedance ?
How to calculate fault level of 11 KV system
