Interested to Buy Any Domain ? << Click Here >> for more details...
What is meant by rating error prevention in breaker??
- 1 Answers
- 4289 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / william lobo
Security
Rating error prevention ensures that the circuit-breaker of
matching rating only gets fully inserted into the cradle.
This prevents any human error during assembly of the
components.
| Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
What are the specifications for conducting earth leakage test as per IEC standard?
if 3400kw slipring motor rotor shorting done and motor started on mv drive ,what will be the rotor shoring current
According to IEC60034-14, When the vibration monitoring system required for motor Bearing. above which KW, it is required? and for what type of bearing the vibration probe is provided.
at what basis/standard we have to arrive the current density of aluminium/ copper in busbar?
What happen if we apply square wave or traiangular waveform voltage to the transformer primary winding instead of sinusoidal wave?
What is meant by Load Encroachment in OHL Feeder Protection?
How to calculate energy stored in an inductance?
what happens when dc generator coupled with cycle shaft.also explain what happens when its loaded
What test must you do before powering up a circuit that you have been working on?
can any one provide me a connection wiring diagram for a DG set control panel along with BOM?
Is it possible to measure correct value of earth resistance & cable insulation ristance with out disconncting earth lead & both sides of cable ends? If not, any other method to measure ER & CIR with out disconneting from the system.
what is the soft starter principle? how is connection diagram? what is the procedure for checking the connection?
ii) A shunt motor supplied at 230V, runs at 900 rpm when the current is 30A. The resistance of the armature is 0.4 ohms. Calculate the resistance required in series with the armature to reduce the speed to 600 rpm, assuming that the armature current is then 20A. [12]
What is the normal phase difference between the voltage and the no-load current in a transformer?
What is line resistance of cable & how it can be measured ?
