Interested to Buy Any Domain ? << Click Here >> for more details...
what is difference b/w tube and pipe ?
- 6 Answers
- 11634 Views
- BSL, Descon, Kirloskar, I also Faced
- E-Mail Answers
Answer Posted / anand swami
tubes r those which is used for heat transfer in a heat
exchanger and pipe is one out side heat exhanger not used
for exchanging heat but used for transportation of fluid or gas
| Is This Answer Correct ? | 7 Yes | 1 No |
Post New Answer View All Answers
Isometric drawings are generated during _________________ phase of a project
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
Can Any body tell me about the Contact or Email id of any good Consultancy which help me to find a job in Instrumentation Field in India .I have Six years of Work Experience in the Same field.Please revert me back on shammi_gwalior@yahoo.com ?
how many types of viberation transmitter and how to calibrate and where use of vibration transmitter
Define the terms Accuracy, precission, Spam, process tolerance while doing calibration of an instrument? Explaini with an example?
what is the current pay package for an instrumentation engineer having 2 years of experience in cryogenic technology???????
Can anybody please let me know Orifice plate sizing calculation formula and step by step procedure
how 3 out of 2 Logic/interlocks works? give brief explanation with help of diagram.
There are two chlorination tonners both are connected to two pressure swithes and the pressure switch is connected to SOV which operates the valve to changeover the tonner selection i.e if pressure one tonner goes low the other tonner should come in line if it is inautomatic selection design a circuit using relays ?
can u plz send me technical questions asked in SCHNEIDER ELECTRICAL technical paper?
what is the PC interface and software for connection to ABB logic module “ LM011-CE18RAC “ ( for Programming ) ??
Can anyone convert a 5/2 way or 3/2 way valve into an ISO valve?
our kks tagging is crossing more than 12 character please suggest how to take tags in the DCS
how do u calibrate the vacuum transmitter if it shows more reading
how many type of plug are used in pneumatic control valve,name them.
