Answer Posted / loboreliance2003
P&ID is Process and Instrumentation Diagram. This is most
important for any process especially related to chemical,
petrochemical plants. It is also known as Piping and
Instrumentation Diagram since in this is mentioned the
various pipelines, valves, instruments location and also
electrical especially control room related.
| Is This Answer Correct ? | 56 Yes | 9 No |
Post New Answer View All Answers
What is the basic difference between Modbus and CAN Open Protocols
What are the materials available to prepare individually for competetive exams in Instrumentation field? Plz reply...
How does temperature bath work? How does coil gets heated only by applying some current?
How to calibrate H2s Dectector
Why do you want to work here
field bus transmitter calibration procedure tell me
What is the diffrence between ff tx and non ff tx
When doing a liquid seal on a differential flow transmitter , most of the time the sealing liquid will be heavier then the process fluid. For wich application will the sealing liquid be lighter than the process fluid if transmitter is mounted below the process line.
What is the calibration procedure of Drum level transmitter if range is 0 to -400 mmh2o in lab?
Why mmwc unit is used?
NPN transistor, SCR, Zener diode, LED, Varactor diode, Vortex meter, RTD, Resistor, Crystal
In VVVF DRIVES VOLTAGE IS ALSO VARY WITH THE FREQUENCY. HOW? WHAT IS THE DIRECT FORMULA RELATING THESE TWO.
How to calibrate level transmitter with use of HART?
Where Can i take a SPI INtools training in Mumbai? In Rolta India Ltd to whom I should approach regarding of SPI INtools Training?
typical loop drawing of a simple feedback control comprising of one transmitter and one control
