Interested to Buy Any Domain ? << Click Here >> for more details...
Technical requirement of Copper earthing over GI earthing.
- 1 Answers
- 5990 Views
- I also Faced
- E-Mail Answers
Answer Posted / cnu
There arent much technical things between the two. the
current carrying capacity of the copper is more than GI.
Iron is prone to rusting after a certain time it completely
stops conducting to ground.
| Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
how to determine motor size for a fan application?
What does the letter CTNM in negative phase sequence relay means?
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
We have Diesel generator of 200KW. fuel consumption is always same,even connected light load or full load. Is it right?
Difference between rating factor of cable and derating factor of cable?
how to caculate cable size for diff types of loads? if anyone know the calculating procedure please tell me
What are the two segments of nyquist contour.
could an induction motor be used for regenerative braking in electric-train control? in this type of application would some scheme have to be devised to obtain low synchronous speeds while braking? would induction-motor drive, therefore, be suitable for passenger service?
we have consol make 3 phase servo stabilizer for cnc m/c. while installing the earth neutral voltage is 1.7 volts at stbilizer off condition and when stabilizer get on en voltage reaches 4.8 volts (new earthing is done and neutral is helthy condition all phase to neutral volts 440,442,441 v)why this happen.solution for cause.
HOW TO CALCULATE EARTHING SIZING?
Differentiate between ideal and non-ideal voltage sources?
what is gas turbine intercooling ?
what is the transiant condition in alternator? and how it can be prevanted?
What are two contours of nichols chart?
what is meant by moulded case circuit breaker ?
