Interested to Buy Any Domain ? << Click Here >> for more details...
what is the function of anti-pumping in circuit breaker?
- 20 Answers
- 116948 Views
- Aditya Birla, INEL, NCC, I also Faced
- E-Mail Answers
Answer Posted / shirish
The function of closing coil is to close breaker,it is
designed to take supply for few seconds,if we give
continuous supply to it burns,so to prevent burning of
closing coil,after closing of breaker closing coil must be
bypass,and this is done by made arrangement for bypassing
closing coil after breaker closure,
so if above condition is achieved and then breaker is close
,we can not operate closing coil and it is prevented from
burning ,this system is called anti pumping
thanks
| Is This Answer Correct ? | 31 Yes | 12 No |
Post New Answer View All Answers
A 3-phase IM is supplied from 50 Hz system. It runs at speed of 1440 rpm and slip equal to 4 %. Calculate number of pole pairs. A 1 B 6 C 2 D 3
Why front mounted CT polarities are always towards breaker?
In Dyn11 power transformer if any one of the 3 phases connected to earth in star connected side then please explain effect of the current flow in delta connected side of transformer.(In this case if one phase is shorted to ground in star connected side then we observe the current flow in two phases only not three phases in delta connected primary side. Please explain why it is so?)
If we use 250A MCCB as a incomer in Control panel for a fault level of 50kA for one second ,assuming temperature rise from 85 Deg. to 100 Deg , Then what will be the Aluminium Bus-bar size for 250A MCCB? Explain in detail.
i want use the cable size 16cx4 core aluminium usege watts 240x2000w this cable size is correct?
role of europe union in UK safety legistlation (electrical safety)
How can eliminate noise problem inside temperature controller temp. variation due to contactor chattering problem.
Circuit diagram of tube light without starter using electrical choke
tell me about roaster switch .& what is the function in transmission & distribution?
Can u tell me design of switch yard
state the working of discharge lamp?
(1)WHAT HAPPENS WHEN SUDDENLY LOAD GIVEN TO THE INDUCTION MOTOR ? (2)CAN WE MAKE WOOD AS MAGNET ? (3)WHAT IS THE VALUE OF MAGNETIC FLUX DENSITY IN TRANSFORMER ? (4)WHY WE ARE USING ELECTROMAGNETI NOT ELECTROSTATIC IN MACHINE ?
sir i want previous entrance exam papers for written test
Explain RLC circuit?
a 100mva,400/200v transformer has leakage impdce of 10% draws a steady state line currentof---------------
