Answer Posted / meenakshi
higher power-to-weight ratio,Electricity enables faster
acceleration and higher tractive effort on steep grades.
lack of exhaust fumes at point of use, less noise and lower
maintenance requirements of the traction units.no need to
switch between methods of traction thereby making
operations more efficient
source: wikipedia
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
SIR, GIVE ME OPGW SAG CALCULATION FORMULA I AM DAE ELECTRICAL. THANKS
What willbe change in programming when we use 5/3 solenoid inplace of 5/2 in operating of a cylinder?
How will polarity test of Dy5 Transformer ?
why do we use 25kv supply for traction purpose?
What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer?
where is core-type and shell-type construction suitable for transformers ?
how can decide the current rating of oltc
CAN WE CALCULATE THE NEGATIVE SEQUENCE AND ZERO SEQUENCE REACTANCE OF A GENERATOR USING ONLY ITS RATED VOLTAGE, KW, PF AND SYNCHRONOUS REACTANCE??? IF YES, THEN HOW??
What are the causes of unbalanced current on 34.5kv feeder Ia=0.05,Ib= 0.25, Ic=0.15 and In=0.27 prior to tripping current are balance?
-What should be minimum value of insulation resistance and maximum value of earth resistance at any electrical instillation and what is method of testing the same.
why we change the direction of winding in rotor ?how we make the north and south pole?
How to reduce -234126219.6403 MVAr generation and by what?
i am an maintenance engineer. one distribution board have 5 feeder. recently its ELR trips frequently, but it take some times after trip( 10min,20min..)but 3 feeder no load. two feeder only loaded. i checked one feeder IR value all values are above 50Mohm.but B phase to Earth is only 9Mohm.any problem about low value
Which device of PlC does share load between DG sets when DG are running in perallel?
The windings of a transformer are divided into several coils, because?