Interested to Buy Any Domain ? << Click Here >> for more details...
What is the function of automatic Transfer Switch(ATS) in
details
- 3 Answers
- 25479 Views
- I also Faced
- E-Mail Answers
Answer Posted / gopal varsani
ATS is the Automatic Transfer Switch, The function of this
switch is that if the utility supply goes then the
connected equipment would be transfer automatic on
emergency source from utility source through this switch.
But it is programed few second delay asper sefty rules becose
when incoming flickering or sparking that time it should not go on where incoming sores are connect healthy that switch may go on
| Is This Answer Correct ? | 18 Yes | 0 No |
Post New Answer View All Answers
how to electrically make connection to ferroli GN2N?
Alternator rotor earth fault relay circuit
In electrical what is earth(ground)connection, wht is the importance of it, why it is recomended to maitain below 3VAC between Neutral and earthspecially in PLC used machines?
Hi, Next week Iam appearing RRB exam for section engineer. So help me to get modal question papers for this position. Iam very thankful to you. Whether question will be fully techanical format or general form. Please give me a details regarding this exam.
What happens if the negative to earth voltage is greater than positive to earth voltage in the battery of substation?
What is the comparison of PILC and XLPE cable
I WANT TO know WHICH WAY IS BETTER FOR CONNECTION BETWEEN POWER TRANSFORMER AND MAIN DISTRIBUTION PANEL. 1-IS BETTER WE USE CABLE? 2-IS BETTER WE USE BUS DUCT? my transformer rate power is 2500KVA
how harmonics generated in induction furnance? how minimise it?
Why should we hire you over the others waiting to be interview?
what type of motor used to move a 1 ton gate? and relate ratings with load.
th how could we differentiate between armoured copper and armoured aluminium cable what is the basic application? why we prefer the armoured copper as compared to armoured aluminium.
If only R Phase is connected in 2 pole elcb, n is not connected than it will work or not in ground fault.
what r PID controllers?why they r used?what is there purpose?plz Explain in detail
why we use 630mm single core cable for transformer secondary side and why two neutral cable
if we give 60 hz single phase supply to the transformer used in europe , than what will happen
