Answer Posted / asaf
removal of load from supply over certain periods when demand
become greater than supply.load shdding is also known as
rolling blackout. load shedding are in response to
insufficient resources inability to meet demand for suuply.
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
SIR, GIVE ME OPGW SAG CALCULATION FORMULA I AM DAE ELECTRICAL. THANKS
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
Is there any type of starter for DC motor other than two point,Three point and Four point starters?
what is the setting of locked rotor in HT motor ? (answer expecting in percentage)
Two liquids hot and cold in two vessels are there and an metal bar acts as a conductor of heat between the two vessels. what happens then. what happens after 24 hrs?
hi Is there any possibilities to find out the rotation of a shaft or something else by using electromagnectic waves or by IR rays.If s then can v change the dir., of rotation of the same by remotely?& how? plz dn't any1 say "NO r CAN'T"
A TRANSFORMER 440/400V,DELTA/STAR CONNECTED.THE NEUTRAL CONNECTED WITH GROUND CABLE THAT IS DIRECTLY CONNECTED TO THE PANEL,FROM PANEL IT IS CONNECTED EARTH PIT.IS IT RIGHT? IF IT IS RIGHT LEAKAGE CURRENT AFFECTED.SECONDATY IS PROTECTED WITH EARTH LEAKAGE RELAY.
How does cost of generation from hydropower plant compare with other sources of electricity?
what should be the acceptrd value of winding resistance for 2.5MVA transformer
explain PV modules in solar energy generation.
what is subtransient , transient and steady stateac components
In power transmission using open belts or horizontal shafts it is preferable to have the slack side of the belt on the top because
Why sometime AVR and sometime Booster coil is used in Alternator? what is the diferance between AVR & Booster coil due to which they are selected
Draw a circuit diagram in which if button is open we can use socket and bulb as a series test circit and if button is close than simple we can use socket as any load purpose.
what is destructive and non-destructive testing of welding
