Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / rajneesh upadhyay
in transformer there is no moving part so there is only
iron loss
copper loss
stray loss
iron loss :can be categorise in two part
hysteresis loss & eddy current loss
hys lossis due magnetizing and demagnetizing effect of core
due to ac current . because core is not completely
demagnetize in one half cycle of current some current is
used for demagnetize is this loss ocurr
eddy current loss is due to loop of magnetic line in iron
portion of transformer which should not in core this can
minimzed using thin lamination of core and si content of
core
cu loss is due to resistance of cu portion in windind
IF DONT AGREE PLZ SUGGEST RAJNEESH.GCA.MMMEC@GMAIL.COM
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
how can we calculate the ampacity of the electrical wire/cable. and what are the factors must be considered. pls. elaborate.
does buccholz in a transformer use batteries
where rlc series ckt used?
1.What is the range of stator resistance of 3-phase induction motor? 2.Two electrically operated vibro motors are foxed in parallel direction in vibrating feeders. what is the direction of both vibro motors?
What are the symptoms of a bad PG card of a drive (inverter) esp. of Yaskawa Ac Drives (inverters) G7 ?
how to calculate IR value of 33KV cable ??
how choose conductor&depending upon load
Please explain me about Relay curves and their sources to read ?
State the other types of Air Conditioners?
What are the various types of rotor used in the alternators?
how does grading rings & spacers in transmission line works? Working Principle?
Why AC current leads voltage in capacitor and how?
How would your past experience translate into success in this job?
I'm generating a pulse of 3V with frequency 80Hz (12.5ms time period) and pulse duration 0.125ms and feeding it to a transformer since i want the pulse to get amplified around 60V. At the output amplification s happening but the pulse is changed to a spike, can you tell me what could be the reason? (an ordinary transformer 220V-12V stepdown transformer is reverse connected ie. now it is 12V-220V stepup and voltage amplification happens)
What are operating procudures & Safety precautions to be observed while operating OLTC in manual mode ?
