Interested to Buy Any Domain ? << Click Here >> for more details...
Explain the working principle of Vacuum circuit breaker and
Air circuit breaker
- 10 Answers
- 48870 Views
- HP, Trinidad and Tobago Electricity Commission T TEC, I also Faced
- E-Mail Answers
Answer Posted / siddharth
when fault occure contacts of C.B. open. At that time arc
produce between fixed and moving contact.
C.B. is required to extanguised that arc.
In vaccume C.B. contacts of C.B. placed in highly vacuumed
bottel (i.e there is on any gas or air). For continuty of
arc oxigen is required. There for arc will be vanished.
In air C.B. there is arc spliter to quanche and to
langthand the arc. Due to long length arc resistance
increased and there for flow of current. So that arc
extinguished.
| Is This Answer Correct ? | 9 Yes | 6 No |
Post New Answer View All Answers
Differentiate between voltage and current feedback in amplifiers?
advantage of motor design on higher power factor . normally motors are designed for .8 power factor. what is advantage of designing at .88 power factor
Why corona leads to production of Ozone and glow of the color VOILET?
what is mppt (maximum power point tracking ) and how they used in solar power generation ??? what are the main components used in mppt?????
why incomer bay is required before transformer bay if there are more than 1 nos. of transformer bay.
What is the use for cable entry in control room?
SUTIABLE FOR ohm's law super conductor
r we are using in gas turbine mark (5) frame (6) (made in india Bhel 1997) Ā
What are IR values and what it should be for coil and for insulator
How to calculate no of Lighning arrestors are required for protecting 50mX 50m*20m cubical building and locations of LA?
If there are two transformer having rating of 2.5mva, 6.6kv/440v(satr-star),and the load is 600kw then what is better to maintain less losses in transformer having both transformer in parellel or only single transformer connected to load? Please give calculated answer
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
How REF protects transformer alone? explain with diagram.
A power transformer 4MVA/11KV/0.415Kv has been out of use in 12years. what maintenance actions/test need to be carried out before energizing.
a governer in an Ic engine controls the
