Interested to Buy Any Domain ? << Click Here >> for more details...
What are the loads considered when designing the Nut and
Bolts?
- 12 Answers
- 21197 Views
- I also Faced
- E-Mail Answers
Answer Posted / ajay
shear load and crushing load
| Is This Answer Correct ? | 1 Yes | 3 No |
Post New Answer View All Answers
how can I masurement the circale weight ? like- 312mm i/d x 392mm o/d x 6mm thick.
Explain what does green field project mean?
Hello Friends I had my ONGC test today,but it was very bad.But I would give certain suggestions so that u may not face he problem which i had. Be thorough with Electrical Technology.Generators.motors stators etc.There are 5 questions on that. There were also good no.of questions from Hydraulic machine and Production technology. Then 3 from Strength of materials.And remember the dimensional quantities.
What is IS standard in case of mode of measurement for ducting
What is method to calculate the noise level at any point of duct if duct dimensions and air flow is known?
where is the steam trap connected in boiler distribution?
If anybody have the ref. design book of the 3 point cylindrical rolling with sheet thickness of 2.3 mm & 67 mm internal diameter legth of 80 mm
Why would you use hydraulics rather than pneumatics?
what is the magnetic (electric) center)
What are the causes of damage to propellers?
why do u ant to join the indian army??
What kind of paper airplane flies the farthest?
What are the causes of positive and negative propeller slip?
What are the things to do when approaching the port?
How does iron ore turn into steel?
