Interested to Buy Any Domain ? << Click Here >> for more details...
WHY EARTHING NOT NEEDED IN BATTERY IN SUBSTATION?
- 5 Answers
- 16299 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / cnu
Basically a device is earthed to avoid any stray
circulating current that appear on the body of the device
operating with an AC supply.
since AC creates an alternating flux. this changes in flux
induces stray currents in the metallic body of the devices.
When coming to DC, since it is a constant voltage it does
not produce flux change to induce any currents so earthing
is not required for a DC battery.
| Is This Answer Correct ? | 15 Yes | 3 No |
Post New Answer View All Answers
I would like to know that the fault curretn at base load and at 10% generation will be same? Fault level of BUS remain same with different generation?
How to calculate the sag of OPGW during stringing???
please write motor, transformer, Generator setting, fault level calculation of Tr.etc
how to avoid Saturation in C.T?
Showing results for capital, machinery, stock,wages, carriage in words, salaries, factory rent, repairs, fuel and power, buildings, debtors, sales, purchases, creditors, return outwords, return inwords, drawings, discount allowed, discount receivable, office expenses, bills payable, bills receivable, cash in hand, cash at bank, office rent comes under debit or credit
What are the two segments of nyquist contour.
what is the diff. between x'mer , isolation x'mer & ultra-isolation x'mer ?????????????
i want design of D.C.MOTOR 1HP 960RPM AND 2HP 960RPM ITS URRGENT
Why field rheostat is kept in minimum position?
If you have an earth with pilecap then your resistance is really low. why and how?
Explain with example of functional requirements of protection relay in terms reliability, selectivity, sensitivity
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
If short circuit ratio is high is it bad or good for a machine then tell the reason...
Can 33kva/415v transformer be run underground? If the answer is yes why and if the answer is no why?
What is Bolted fault?
