Interested to Buy Any Domain ? << Click Here >> for more details...
PID controller is used for which type of compensation……
a) lead comp. b) lag com. c) lead lag com.
- 12 Answers
- 23941 Views
- Engineers India Limited, I also Faced
- E-Mail Answers
Answer Posted / jobby c johnson
lead-lag compensation
we know derivative action provides a +ve phase angle and
integral action provides a -ve phase angle
| Is This Answer Correct ? | 12 Yes | 0 No |
Post New Answer View All Answers
What is profibus?
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
If i have 4 Allen Bradely make RS logix 5000 PLC and for viewing that we are using 4 RS view SCADA for 4 different packages. Now, I will want to view two packages on only one SCADA. Then how i will do it?
OBJECTIVE TYPE QUESTIONS OF ANALYTICAL INSTRUMENTATION
What is ultrasonic flowmeter?
What is the difference between conductive lined pipe and conductive unlined pipe? Why do we see that?
-/5A. What is the meaning and limitations of this in energy meter constant. It is a 3 phase LT Energy Meter. If this Energy Meter is connected through a CT of ratio 200/5 Amps, then what is the multiplying constant and how its will be calculated.
what should he know if he is an assitent engineer instrumentation in cement industries of experience of 10 - 15 year.
what would be the minimum flow rate that we can measure on rotameter..?
How to convert milliampares into flow??
how will you segregate the alarm levels in alarm management system during factory Acceptance Test
Displace type LT to be calibrated in workshop, wt. 40, dia- 60 mm, density- 0.8kg/cm3.
Which products are available in the Mass Systemswitch and System Manager AC range?
What are the key features of a Distributed Control System? describing the various layers (sensor through to business system interfaces) as well as the hardware, software and security aspects of the DCS.
A length of steel pipe is used to carry sea water to a desalination plant. An adequate corrosion allowance must be specified and indicated in the piping specification, which affects the _________________________ of the pipe
