What is cascade control in process instrumentation?
- 4 Answers
- 22833 Views
- Engineers India, ITC Infotech, I also Faced
- E-Mail Answers
Answer Posted / abhishek vyas srf limited
Best example of cascade control is level control of a
tank. first taking care of it's actual level( getting
signal from level transmitter) then controlling it's flow.
so only controlling element is flow and level singnal will
work as a setpoint for flow controlling.
There are two controller used one for level whose
controller o/p will work as a set point for flow controller
then final control signal from flow controller will actuate
the control valve. Thus actual level will achived.
| Is This Answer Correct ? | 25 Yes | 3 No |
Post New Answer View All Answers
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
What is the difference between conductive lined pipe and conductive unlined pipe? Why do we see that?
how pressure transmitter work, what is its principal to measure and how its generate signal. for pressure transmitterinstallation which precautions must be taken ??
i am having information technology branh ....... can i prepare for psu exam
it is possible to check the fail safe condition in pressure transmitter. if possible how?
Calibration procedure for Electro magnetic Flow meter
What is compensation for flow ? Why we use compensation ? What are the factors of different compensation ? We not use then what problems may happen ?
How to calculate P,I&D value in PID controller ?
What is wet leg condition and why is it used?
What is the cascade control
What is three element drum level control system why its better than single element?
what is the electrical operation procedure for switching on 27.6MVA electric furnace.
what is function of switch, and how is it work, explain with difination
What happen if I install my pressure transmitter below the elevation of pipe in natural gas service?
Which Signal hart communicator work? If there any signal change when hart connect while transmitter in line ?
