What is the basic principle of vibration measurement by
BENTLY NEVADA vibration measurement system? and Why it
gives the -ve voltage output?
Answer Posted / guest
ENTLY NEVADA vibration measurement system? and Why it
gives the -ve voltage output? ya
Is This Answer Correct ? | 26 Yes | 13 No |
Post New Answer View All Answers
what is the difference between magnetic flow meter and mass flowmeter
what is droop in governer ,type of droop ,how it work
why we are using drum level control valve air to close?
IS there any effect of vortex in low pressure side of the transmiter after the orific in feed water line? if yes then what is the calculation?
How do you identify an orifice in the pipeline?
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
Explain bernoulli’s theorem.
Draw a group of instruments interlocked to a Pump & Motor?
i am preparing for BARC ,so plz mail me how to prepare for BARC. ALSO IF POSIBLE SOME RELATED QUESTIONS. MY MAIL ID IS khushi_4uall2003@yahoo.co.in
What are different types of orifice plates?
Why we are using reverse action in displacer types level transmitters on some Vessels?
What is Erosion in a control valve?
Why are the uses 24vdc in industries
how the arrangement of equipments done in control room
principle of dead weight tester ?