what will happen if we use earthing inplace of neutral for
domestic energy meter
- 5 Answers
- 7857 Views
- Polyplex Corporation Limited, I also Faced
- E-Mail Answers
Answer Posted / arvind
I think it should work because here only return path is
change instead of neutral, now here is earthing
| Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
can we install HT panel & LT panel side by side or how much clearance is required ?
we have a lot of model of rectifier but thyristor rectifier is the most rectifier that use in power system. Do you know why this rectifier is used?
In both 600/1000 V cable and 450/750 V cable, we can supply 415 V. However for distribution, all utilities are using only 600/100 V instead of 450/750 V. What is the reason?
what is the total power generation in india?
If a surge divertor is required to be protected by 32 amp C Curve Circuit breaker does this limit the amount of protection from surges that you will acheive
how to increase or decrease speed in DC shunt motor by DC convertor
I meggared my 2c*70 sq mm AL AR XLPE cable. its one end show 50 M ohm . is my cable is safe for laying. I have only one phase and neutral.
A 7 storey building has a floor area of 35,000sq.ft on each storey. On the ground floor 11KV electrical sub-station is to be erected. A load of 3kw for every 400sq.ft (p.f is 0.8) is proposed for each floor. fire pump 7.5hp, water pump 5hp, lift 2 nos, each 10hp and 20shop load of each shop is 5kw. calculate a. load each floor b. total load of building c. L.T feeders for aech floor and from transformer to main. d. distribution diagram e. capacity of sub-station/capacitor bank f. line diagram
What is the drawback of static coefficients?
can a 150 kva 3 phase 440v/230V delta-wye step down transformer can be use as step up transfoermer with connected loads at 440v side?
I want the details about BHEL company examination.Can anyone able to help me please.
what are the interview question asked in wind mill about electrical
i want design of D.C.MOTOR 1HP 960RPM AND 2HP 960RPM ITS URRGENT
why we can stote dc? why we cant store ac?
what is the saturation point of crgo lamination.
