Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sonu pal
if dc will flow to earth,there will be cause of fault.
| Is This Answer Correct ? | 2 Yes | 13 No |
Post New Answer View All Answers
Is potential difference materials property ..? if yes tnen how.. explain brifly.
how to know the diffrential relay setting of 06mva step- down (delta-star)transformer?
how to select the automotive wire size by mathematical calculation. for xenon headlamp with ballast. the ballast given data voltage 10-17v,current permenant 6amp, run up phase is 15amp, peak at swicth on max 400micro sec is 40amp.the sum of cable resistance is 150mohm.please provide referenc document if any for relating the peak at switch on current,time & wire wire size
Why PT voltages are measured with respect to ground? What do u mean by voltage or current polarized.
How many types of faults are there in 3 phase power system?
When we have earthing mesh or underground earthing network in industrial plants, weather we have NT-S or NT-C-S kind of earthing system, so eventually weather we must use 4 or 5 wire in 400 volt level (For example 3×150+70 mm2 or 5×150 mm2) in this connection I would like to know exactly the paragraph of IEC or IEEE number
what is the earth current,reverse power,electrical trip generator short circuit,low voltage, high voltage please discribe me
What should be the Sandwitch type Al. bus bar capacity for 2 M.W.Gen. set, having continuous full load current- 3463 Amps,ambient temp.- 50 Deg. C., Required temp. raise-20 deg.C., it will run 24 hrs, 365 days on full load, required highly reliable.
what is difference between bus coupler and auto transfer switch
Why current shoots up in the secondary on the knee point voltage during saturation test of CT? How core saturation effects the secondary current (while the primary side is open)? What the logic behind this?
If mutual flux is 1.2wb & power factor is 0.8 lag , then what is the Useful flux of a transformer?
Compare salient pole and cylindrical rotor machines.
How to calculate the phase to phase clearness of HT /// LT bus bar?????
how to calculate
From past few months I am getting lagging pf even though sufficient capacitors used in circuit. Where is the problem pls answer
